Adding water into a map

  • Please note that answers to questions that receive more than 5 collective down votes will be automatically hidden.

Mikey

Howdy.
Feb 6, 2018
356
Just wondering how to add water to my terrain? I want to add a ford to my country lane.

Thanks!
 

Road-hog123

An Orange Bus
Administrator
UKDT
Dec 10, 2015
1,784
In the "Tile" tab of the Editor, there is an "Add Water" button. This adds a water layer to the current tile.
In the "Terrain" tab of the Editor, you can switch between affecting terrain or water. You then use the same terrain editing tools to raise, lower and set the height of the water.
Note that the water can only be adjusted in the 4 corners of the tile, so other areas at the same height on the same tile will also flood. OMSI's water implementation isn't good, more realistic results could probably be achieved with some custom models and good texturing.
 

Mikey

Howdy.
Feb 6, 2018
356
In the "Tile" tab of the Editor, there is an "Add Water" button. This adds a water layer to the current tile.
In the "Terrain" tab of the Editor, you can switch between affecting terrain or water. You then use the same terrain editing tools to raise, lower and set the height of the water.
Note that the water can only be adjusted in the 4 corners of the tile, so other areas at the same height on the same tile will also flood. OMSI's water implementation isn't good, more realistic results could probably be achieved with some custom models and good texturing.
Thanks Roadhog that's a great help.